Problem with RPM after setting higher BHP

[lambogtr777]

Hi,

 

I replaced Farboud with COMB@T_$HOTGUN's Supra, then i used TDUPE to set BHP to 950.

Everything works fine except when i accelerate on neutral, RPMs wont low, they stay at ~6000 RPMs

 

Some help please.

[Myst1c Vo1d]

yup, that's a funny physics engine bug. The model on which the car was made on as a template or donor, was probably a low power car. It's the same when you modify the SSR to have 1000 bhp, it just revs up to 5000 and stays there.

 

What you can do is either lower the bhp a bit to, say, 600 bhp and modify the acceleration and drag. Done that with mine and then it runs really good.

If you want to keep the near 1000+ bhp, you'll need to adjust the inertia of the engine, mostly down but sometimes up. Experiment with that a bit, nothing can go wrong.

[Rassva]

Myst1c you do not know what you are talking about , he is experiencing a BTRQ problem , this happened to me with Zoqqers Veyron a looooong time ago , you just need to replace the BTRQ with the one from the Ferrari 360.

[yocktan]

set proper engine inertia, torque, acceleration. I made 7000 HP 8800 Nm big block Viper.